Hello everyone, today I am discussing how to change the battery on a light lego brick easily. This colorful kit consists of 7 of the only 2x4 battery-powered lights for Brick Loot-easy to illuminate your favorite lego lights set or custom build in seconds. LEGO and other broad brand bricks and baselines that are compatible with each block.

Including the colors

Blue, Green, Translucent, Red, Orange, Purple and Yellow

This range is a fantastic addition to your LEGO party classics and a perfect supplier to your LEGO fans!

• Set up and drive your light kit: our plug-and-play interface makes it fun and simple!

2 AG3 batteries are used in each brick,

Which can easily be replaced by adult lego lights and other broad brand bricks and plates are compatible with all battery bricks.

• For clear plug-in and play instructions, a comprehensive installation picture can be given here.

Do you need extra batteries?

• .
• Adafruit.com is offering white LED backlights for around $2.50 each.

Backlights use HDTV technology

It spread the light equally from a single LED. As such, these LEDs can be tested with a 3-volt CR2032 button, as shown as a simple " lego lights throwing system." During the test, be sure that the rear light is lit on its side and dark. You could discuss the "front" on the front of the dark side with a Sharpie marker.

• Surprisingly, a single CR2032 war will light up the white LED for almost two weeks, even if it's going to dim over time.

The green backlight

• It is specially arranged but shows brilliant colors by changing the lego lights source's color.
• Since gel color sheets can not add color to white backlights until such colorful backlights are available on the market, please note, however, that you can easily use sharp or erasable markers as a way to make your "boo."
• There is a child safety risk (swallowing) to the CR2032 lithium button batteries.
• The battery holder, which can be closed and twisted, can be used safely for small children. Adult supervision is then necessary for removing the battery.

Both Amazon.com and Adafruit.com

It will supply black 2 x CR2032 to the battery mentioned above the holder. If two of these are available, you can pin the two small screws in one piece to secure the four-screw battery compartment.

• There is a tiny ON / OFF button on the battery holder. For now, could you turn it off?

Important

The CR2032 single 3-volt battery can be used for this project. Therefore, the fabric or "dummy" battery of the CR2032 must be placed on one side of the 2xCR2032 battery holder. As above, lincoln pennies fill the open space.

• The holder supplies 6-volt batteries that can burn two batteries off the lego lights LED.
• Test the final assembly to ensure that only the adult has access to the batteries. If smaller screws do not attach firmly, try electrically typing the battery holder.